Alkali Resistant Fiberglass Mesh Tape is made of alkali-resistant glass fiber cloth as the base material, which is made of non-alkali glass fiber yarn interwoven with a special structure-leno weave, and then subjected to high temperature heat setting such as alkali resistance and strengthening agent Treated, and then baked with a self-adhesive coating.
Reinforcement concrete alkali resistant fiberglass wire plaster mesh tape fabric can be widely used in buildings inside and outside wall insulation, waterproof, crack resistance and so on. Fiberglass Mesh cloth tape is mainly alkali-resistant Fiberglass Mesh cloth.
Main properties and characteristics:
1. Good chemical stability. Alkali resistance, acid resistance, water resistance, cement corrosion resistance, and other chemical corrosion resistance; and resin bond strong, soluble in styrene, etc. .
2. High strength, High Modulus, light weight.
3, good dimensional stability, stiffness, flatness, not easy to shrink deformation, good positioning.
4.Better impact resistance. (because the net cloth intensity is high, tenacity is good)
5, prevent mildew change, prevent insect.
6. Fire protection, insulation, sound insulation, insulation.
The main uses are widely used in:
1) wall reinforcement materials (such as glass fiber wall cloth, GRC wall board, EPS inside and outside wall insulation board, Gypsum Board, etc.) ,
2) reinforced cement products (such as Roman column, flue, etc.) ,
3) granite, Mosaic Special Mesh, Marble Back Mesh,
4) waterproof roll cloth, asphalt roofing waterproof,
5) reinforced plastic, rubber products of skeleton materials,
6) fire plate,
7) grinding wheel base cloth,
8) road surface with Geogrid,
How To Use:
The use of Self fiberglass adhesive tape is easy and fast, no pre-plastering required, no bubbles. It is used to cover or repair joints, cracks and holes on walls, roofs, etc.
1. Wall must be clean and dry.
2. Center and apply tape over the length of the joint and pressing firmly.
3. Apply a generous first coat of compound over the tape and through the mesh, making sure to completely fill the joint crevice. When the joint has been completely filled, wipe off any excess compound with the drywall knife leaving enough fill the joint crevice. Let dry completely ,then sand slightly.
4. Apply sufficient thin finishing coats to produce a smooth wall surface.
5. Cut of butted do not have a tapered edge. Therefore, special care must be taken to assure proper compound that will require an increased amount of edge feathering.
Production process :
Packing and transportation:
Alkali resistant self-adhesive Fiberglass dry wall joint tape
shrink packing or plastic bag ,
Outer packing: 24 rolls or 54 rolls or 72 rolls/ carton
